Siding

October 25 - November 4, 2020
 
After we finished building our new house in 2008 we demolished the old Norton house we had been living in. It was built around 1930.  In these parts the way folks tend get their demolishing done is to use a piece of heavy equipment to smush the structure into a large pile then set it on fire.  We were interested in salvaging the materials, especially the lumber - chestnut and old growth pine were the materials of choice back then. Luckily we have a son - at the time unmarried and not yet in graduate school - who was available to help out his parents.

There was plenty there that was certainly junk - mostly what was added after the original construction - like the asphalt siding over the pine siding you see above. Recovering materials involves substantial nail removal elbow grease:

Over the years since then I've used a little of the interior siding, for example the doors on our garbage and recyclables closet:

However most of flooring and siding material has been sitting more-or-less out of the weather in a lean-to George built with the rusted metal roofing from the old house. For this garden shed project I thought it was time to break out the exterior siding. It literally had to be dug out of the pile.

The horizontal stick in the picture above is keeping the flooring on the left from rolling into the empty space created by my extract of siding boards. When we stacked this 11 years ago it was all up off the ground. However much of that had "melted" so the bottom boards were in the process of rotting. Then there was a large carpenter ant nest amid the flooring boards.  Wherever there was a gap in the the stacked lumber something had moved in. This one was interesting:

--- apparently some kind of cocoon that I haven't seen before. It was tough stuff - it glued the boards together. It was high time to go through that pile! It's a use-it or loose-it situation.

It amazed me that this little garden shed required a majority of the siding that George had pulled from the old house. The reason is that, as you can see in the top photo, the old house had two sets of windows on each of its four sides, so a large portion of the siding is the shorter boards between the windows.

The old siding was attached to the to the new garden shed using 1-5/8" stainless screws. Using screws for siding is definitely the way to go because it sucks the material in tight and you can pull them out when you are not quite satisfied with the fit.

The first step is to put vertical strips on the corners to butt the siding to. This avoids the little crawl spaces for the bugs and bees to move into that you get if you just run the siding to the corner.

The lack of windows on three sides definitely simplified the process.

The peak takes more time because the angles make measuring and cutting hard. I figured out a good trick for the process: fit the lower board, then take it back down to the saw, set the next piece of siding next to it then use a straight edge and pencil to continue the lines from the lower to the next. After checking the fit of the new piece the first piece is screwed in and the new piece becomes the guide for the next above it. If I find the angle is a bit off then I can adjust it by how my cut relates to the pencil line. It beats the heck out of trying to measure the correct angles on each board with a square since a very small difference in where you make an angle cut leaves you with it-won't-go-in or big-gap. I suppose professionals on the clock wouldn't worry about it and instead hide the gaps with a trim piece.

By the time I got to the east side I had learned to select boards that had been together in the old house to line up the paint gaps:


The siding for the porch side will need to wait for the door installation.



Comments