Roof Frame and Sheath
October 2-13, 2020
As you could see by my last post I'd used plastic sheeting to keep the rain off, but getting a roof over it is critical to prevent damage to the work in progress. I started with the longest board in the project, a 17'6" ridge pole. They don't carry 18' at the lumber yard so I had to settle for a 20' --- it's always fun to figure out how to carry that in the truck!
Placing that board finalizes the slope of the roof. The plan was for a 6/12 roof pitch, but I cut those uprights for 6/12 not taking into account the 3-1/2" height of the ridge pole itself so the pitch ended up more like a 7/12 which is fine because I had not already ordered my roof metal with 6/12 measurements.
You can see its all 2x4 material - not strong enough for any real construction - code requires 2x8 I'd guess - but good enough for a shed with an 8 foot span.
Then the tricky part starts: framing in the skylights. The tricky part is that the flashing around the skylight has to be completely specified before putting in the frame. I was thinking I'd be able to get standard 3"x3" right angle flashing to use under and over like this
_____
|
| |
| |
|______
However the times have changed since the last time I went shopping for flashing because neither Summit Building Supply nor Lowes stock plain right angle flashing. Its special order only from the same company that makes the colored roofing metal. The catalog of their offerings showed only fancier stuff, for some reason called "Denver Flashing"
That has a 4" rise on the bottom piece, so the frame had to be an inch taller than I was planning. Luckily I was able to dig out some rough-sawn 2x6 Douglas Fir we had left from the house construction project 12 years ago. East frame installation in progress:The west frame completed
View from the inside after both done including my home-made plank for working at height:
Next up, so to speak, was the sheathing. Since the roof underside will be exposed inside the shed, I wanted to use some of the old one-by lumber we have from old house and barn. No need to use anything really good of course...
The skylights (former sliding glass doors in aluminum frames) lay at the ready:
Completing the eaves, best to work from the bottom edge back up since you want that outermost piece to be a good one.
Interrupted by rain again, but now the plastic sheet is really effective at shedding.
Between storms I managed to get the eave sheathing finished:
While autumn continues apace:
Using my finger to mask the western sun, I liked the view through both skylight openings!
















Comments
Post a Comment